We highlight key aspects
Product descriptionThe product is made up of power assembly, a heating body and a regulator (thermostat).
The power supply assembly is delivered in a steel housing that is protected from corrosion and usual mechanical loads. It is usually installed near the electric cabinet. Only the cover is visible.
The warming body of this system is aluminum strips covered with polyethylene on both sides, width 6, 8, 10 or 14 cm and 0.25 mm thick.
We lay them under or on the screed in the floor, or below the plasterboard or mortar at the wall settings and pow the low voltage transformed electricity (3 V to 48 V).
We can also pass the heating straps on existing floor coverings.
Due to its innovation and simplicity, the Ekoss heating system can be installed in almost every system or substrate.
The product is made up of power supply assemblies, heating body and regulator (thermostat).
We deliver the power supply assembly in a steel case that is protected against corrosion and normal mechanical loads. It is usually installed under the plaster near the electrical cabinet. Only the cover is visible.
The price is variable and depends on the square footage of the building. Contact us, and we will give you the best possible offer.
The consumption depends on the insulation of the building (floor, ceiling, external walls, carpentry, thickness of the walls...) and the wishes of the consumer, the consumption is not the same at the set 23 and 28 degrees. In ideal insulation conditions, the system consumes 0.030kWh / m2.
This type of heating can be used with all floor coverings, except for shipboard flooring and classic parquet.
The warranty is 20 years on the heaters, lifetime on the transformer, 5 years on the electronics and 2 years on the thermostat.
Srpski
Deutsch
Español
Ελληνικά